Wharfedale EZ-M 10X2 - Manual (Page 11)

16
16
POWER Switch – On/Off
This slide switch turns the unit on and off.
Always power down the EZ-m when it is not in use.
Be sure to turn off all system amplifiers or powered
speakers before turning off the mixer.
17
AC Power Cable Connector
The included power adaptor connects here. Use only the power adaptor
supplied with the mixer.
17
CONNECTION WIRING DETAILS
MIC Inputs (Microphone)
The microphone (MIC) jack is a female XLR connector wired balanced with:
Pin 1 = ground, Pin 2 = hot (+) and Pin 3 = cold (-).
Line Inputs
The mono and stereo LINE inputs are wired with ¼” Tip Ring Sleeve jacks, wired balanced with:
¼” - Tip = hot (+), Ring = cold (-), Sleeve = ground, although standard ¼” unbalanced phone plugs
can also be used, wired Tip = hot (+), Sleeve = ground.
MAIN MIX Outputs
The MAIN MIX outputs are wired with ¼” Tip Ring Sleeve jacks, wired balanced with:
¼” - Tip = hot (+), Ring = cold (-), Sleeve = ground, although standard ¼” unbalanced phone plugs
can also be used wired, Tip = hot (+), Sleeve = ground.
Stereo 2 Track Inputs and Outputs (2TKIN / 2TK OUT)
The Stereo 2 Track Inputs and Outputs (2TK IN / 2TK OUT) are wired with RCA phono plugs and 1/8”
stereo jacks. RCA jacks are wired unbalanced as:
Tip = hot (+), Sleeve = ground (-).
1/8” stereo jacks are wired as:
Tip = Left, Ring = Right, Sleeve = Ground.
Headphone Outputs (PHONES)
The Headphone output is wired with both 1/8” and ¼” Tip Ring Sleeve jacks which are wired as follows:
¼” - Tip = Left, Ring = Right, Sleeve = ground
.
9