Weslo WLEL71807.0 - Manual (Page 5)

5
ASSEMBLY
To hire an authorized service technician to assemble the elliptical exerciser, call 1-800-445-2480.
Assembly requires two persons. Place all parts of the elliptical exerciser in a cleared area and remove the
packing materials. Do not dispose of the packing materials until assembly is completed. In addition to the
included hex keys, assembly requires a Phillips screwdriver , an adjustable
wrench , and a rubber mallet .
As you assemble the elliptical exerciser, use the drawings below to identify small parts. The number in parentheses
below each drawing is the key number of the part, from the PART LIST on page 14. The second number is the
quantity needed for assembly. Note: Some small parts may have been preassembled. If a part is not in the
parts bag, check to see if it has been preassembled.
M10
Washer (35)–2
M10 Split
Washer (59)–2
M10 Nylon
Locknut (33)–6
Pedal Arm Bolt Set (40)–2
M6 Nylon
Locknut (27)–4
M10 x 25mm
Patch Screw (22)–2
M10 x 75mm Carriage Bolt (34)–4 M10 x 68mm Button Bolt (48)–2
M6 x 38mm
Button Bolt (50)–4
M6 x 45mm Flat Head
Screw (36)–4
Wave Washer
(64)–2
M6 x 18mm
Screw (43)–4
1. Identify the Front Stabilizer (10), which is narrower than
the Rear Stabilizer (not shown). While another person
lifts the front of the Frame (1), attach the Front
Stabilizer with two M10 x 75mm Carriage Bolts (34)
and two M10 Nylon Locknuts (33).
10
33
34
1
1
33