Wasp Bar Code CCD - 80SIR - Manual (Page 5)

Installation
The CCD scanner can be easily interfaced to a
keyboard or a serial port to your computer. Now
follow the procedures below for a proper installation.
On your first time installation, it is necessary to select a
compatible computer type. (See the configuration
manual for the correct type.)
To install the scanner as keyboard wedge:
1)
2)
Plug the phone jack of scanner cable into your
CCD scanner.
Turn off your computer.
3)
4)
Remove the keyboard plug from our computer,
plug it into the Din-5P or PS/2 female connector of
scanner cable, and then connect the Din-5P or
PS/2 make connector to the keyboard port of your
computer.
Turn on the power of computer, the red LED
indicator will light and the CCD scanner will beep
to indicate a correct installation.
To install the scanner as a RS-232C device:
1)
2)
Plug the phone jack of scanner cable into your
CCD scanner.
Turn off your computer.
3)
4)
Plug the DB-9P female connector of serial cable
into RS-232C port on your computer.
If it is necessary, plug another end of DC jack to
the adapter.
5) Turn on the power of computer, the red LED
indicator will light and the CCD scanner will beep
to indicate a correct installation.
General Scanning Tips
You can optimize performance by changing the
position of the scanner with respect to the barcode
labels. Please note the help hints below to ensure an
effective scanning with the CCD scanner.
* Center the reading aperture on the barcode label.
* Touch the label with the reading aperture.
* Hold the scanner within a distance of 0-20mm from
the barcode label.
3 4