Windsor MINI CARPET EXTRACTOR MPRO 10080390 - Manual (Page 17)

MAINTENANCE
86037780 EXTRACTOR 12/09/06 4-5
TROUBLESHOOTING CHART
PROBLEM CAUSE SOLUTION
Is the cord plugged in. Plug in cord.
Circuit breaker tripped in building. Reset breaker
Faulty switch. Call for service.
No power, nothing runs
Faulty power cord or pigtail. Call for service.
Vacuum circuit breaker tripped. Reset breaker
Faulty main switch. Call for service.
Loose wiring. Call for service.
Vacuum motor will not
run
Faulty vac motor. Call for service.
Debris lodged in vac shoe. Remove debris from vac shoe.
Dome gasket defective or missing. Replace as necessary.
Vacuum hose cracked or hose cuff loose. Replace or repair as necessary. Vacuum motor runs but
suction is poor
Recovery tank full. Turn off vac motor. Drain and rinse
recovery tank.
Switch to accessory mode. Turn to deep clean position.
Jets clogged or missing. Clean using a vinegar /water solution or
replace.
Solution filter clogged. Drain solution tank and clean solution
filter.
Poor or no water flow
(carpet is streaky)
Faulty solution pump. Call for service.
Switch in accessory mode. Turn to deep clean position.
Brush circuit breaker tripped. Reset circuit breaker.
Brush belt broken. Replace as necessary.
Brush does not spin
Faulty brush motor. Call for service.
Accessory tool fitting
difficult to connect
Corrosion on fitting.
Clean with steel wool.
Remove and soak in acetic acid (white
vinegar).
Lubricate lightly with silicone base
lubricant.