Whistler TOTAL BAND PROTECTION XTR-500 - Manual (Page 3)

13. Dual Alert LED Periscope - provides added
visual alerts of threats ahead.
INSTALLATION
Mounting Guidelines
• Mount the unit as low as possible near the
center of the windshield.
• Do not mount the unit behind wipers,
ornaments, mirrored sunscreens, etc. These
obstructions have metal surfaces which can
affect radar and laser signals and reduce
critical warning time. (Regular tinted glass
does not affect reception).
• Some windshields have an Instaclear ™ or
Electriclear ™ type coating, which affect radar
signals. Consult your dealer or the owner’s
manual supplied with your vehicle to determine
if your windshield has this coating.
• Avoid placing the unit in direct contact with the
windshield.
• To reduce the possibility of theft, conceal your
unit when not in use.
IIM MP PO OR RT TA AN NT T: Make sure the unit is level
FEATURE DESCRIPTIONS
Windshield Mounting
• Install the two suction cups and rubber bumper
onto the bracket by fitting them into their holes.
• Press the suction cups onto the windshield at the
location you have chosen.
Important: Some newer cars have a plastic safety
coating on the inside of the windshield. The wind-
shield bracket may leave permanent marks on this
type of surface. To find out if your vehicle has this
type of windshield, check the owner’s manual or ask
your dealer. We recommend that you do not leave
the suction cup bracket on the window in direct sun-
light. If the detector is removed, this may cause
blistering of the dash in some vehicles.
• Slide the detector onto the bracket until it locks into
place.
• If necessary, the unit may be leveled by bending the
windshield bracket. Press the bracket release button
and remove the detector before bending.
Power Cord Connection
• Plug the small end of the power cord into the
unit’s power jack.
• Plug the large end into the vehicle’s cigarette lighter.
N No otte e:: Cord fits tightly into detector. When
installing the cord, expect some resistance.
Fuse Replacement
The lighter socket plug is equipped with a
replaceable 2 amp 3AG fuse located behind the
silver tip. To replace the fuse, carefully unscrew
the tip of the plug.
IIm
mp po orrtta an ntt:: Unscrew slowly. The tip contains a
spring which may fly out when disassembling.
Insert the new fuse with the spring and screw on
the tip. With use, screw cap on plug may loosen.
Retighten occasionally.
INSTALLATION CONT.
Windshield
Mounting
5 6
Rubber Bumper
OPERATION
7
Dim/Dark Mode
Dim/Dark Mode reduces the illumination of the
display.
• Press the Dark button to reduce illumination
to a Dim setting.
• Pressing the Dark button a second time
engages Dark Mode. The display illumination
is further reduced.
Dim or Dark Mode can be engaged during an
alert. In Dark Mode, the display goes dark for as
long as a signal is being detected and for 20
seconds after, then the display returns to the
dimmer setting.
• Pressing the Dark button a third time restores
full illumination to the display.
Power On Self Test & Volume
Each time your Whistler detector is turned on,
an automatic self-test sequence confirms that
the speaker and visual displays are functional.
To increase volume, continue turning the
volume knob.
• Display shows in order:
1. WHISTLER 2. X-band 3. K-band 4. Ka-band
5. LASER 6.. SR OFF 7. VG2 OFF 8. POP ON
9. B SVR ON 10. HIGHWAY
Setting Saver
Setting Saver saves your personalized settings
so that when the detector is turned off and then
on again, you do not have to re-enter them.
Feature Engaged Confirmation
Each time a button is pressed, one beep confirms
feature “on”, two beeps confirm feature “off”.