Whynter SNO Portable Ice Maker Stainless Steel Series T-2C/A - Manual (Page 2)

Introduction
This instruction manual covers the operation of the Whynter portable ice maker models T-
2M/T-2MA and T-2C/T-2CA. Both models provide the same functionality, the difference
being cosmetic. Model T2-M has a brushed/stainless steel finish and model T-2C has a
shiny/bright chrome finish.
The “A” designation refers the units equipped with the optional
functionality of the “Direct Water Supply” mode.
Please read these instructions carefully and retain them for reference.
The appliance must be connected to a (nominally) 110V AC 60Hz earthed electrical supply
and be protected with a fuse.
The Whynter portable ice maker produces 12 ice cubes with each cycle of approximately
12 to 18 minutes, depending on the size of cube selected. The appliance is equipped with
a Function Display panel that includes SELECT buttons for ice cube size selection (S for
small, M for medium and L for large), START and STOP buttons and a WATERTANK
condition monitor which gives a visual warning when the appliance is running low on water.
The unit has a separate mains electricity ON/OFF switch on the back panel.
It is recommended that the appliance is operated with small (S) cube size whenever
conditions allow.
The T- 2“A” models has a dual mode design – “Standard” and “Direct Water Supply”
mode. In Direct Water Supply mode, the appliance can be connected directly to a
mains water supply. This added function allows the water tank to automatically refill
when empty.