Wilton 1230 - Manual (Page 6)

6
240 volt lines 120 volt lines
0-50 feet No. 14 No. 14
50-100 feet No. 14 No. 12
Over 100 feet No. 12 No. 8
Conductor length
AWG (American wire gauge) number
attachment to do a job it was not designed for.
16. Use only recommended accessories and
follow manufacturers instructions pertaining to them.
17. Keep hands in sight and clear of all moving
parts and cutting surfaces.
18. All visitors should be kept at a safe distance
from the work area. Make workshop completely safe
by using padlocks, master switches, or by removing
starter keys.
19. Know the tool you are using — its applica-
tion, limitations, and potential hazards.
Wire sizes
Caution: for circuits which are far away from
the electrical service box, the wire size must be
increased in order to deliver ample voltage to the
motor. To minimize power losses and to prevent
motor overheating and burnout, the use of wire sizes
for branch circuits or electrical extension cords
according to the following table is recommended:
General Electrical Cautions
This machine should be grounded in accor-
dance with the National Electrical Code and local
codes and ordinances. This work should be done by
a qualified electrician. The machine should be
grounded to protect the user from electrical shock.
Safety instructions on drill presses
1. All work shall be secured using either clamps
or a vise to the drill press table. It is unsafe to use
your hands to hold any workpiece being drilled.
2. Drill press head and table shall be securely
locked to the column before operating the drill press.
This must always be checked prior to starting the
machine.
3. Always use the correct tooling. Tooling shall
always be maintained and properly sharpened. All
tooling must be run at the proper speeds and feeds
as they apply to the job. Use only recommended
accessories and follow those manufacturers instruc-
tions pertaining to them. Tooling shall not be forced
in to any workpiece but fed according to the proper
specifications. Failure to follow these instructions will
not only ruin the tooling as well as the machine, but
can cause serious injury.
4. Never brush away any chips while the
machine is in operation. All clean up should be done
when the machine is stopped.
5. Keep hands in sight. Do not put hands or
fingers around, on, or below any rotating cutting
tools. Leather safety gloves should be used when
handling any sharp objects or cutting tools. See
Figure A.
6. Always wear protective eye wear when
operating, servicing or adjusting machinery.
Eyewear shall be impact resistant, protective safety
glasses with side shields complying with ANSI Z87.1
specifications. Use of eye wear which does not
comply with ANSI Z87.1 specifications could result in
severe injury from breakage of eye protection. See
figure B.
7. When drilling in material which causes dust,
a dust mask shall be work. See Figure C.
8. Avoid contact with coolant, especially
guarding the eyes.
9. Non-slip footwear and safety shoes are
recommended. See figure D.
12. Wear ear protectors (plugs or muffs) during
extended periods of operation. See figure E.