Wells WM-TR - Manual (Page 14)

CLEANING INSTRUCTIONS
DAILY CLEANING
PRECAUTIONS: Press POWER SWITCH to OFF (0).
Drain all water from TANK.
Remove tank from Water-Max™.
FREQUENCY: Minimum - Daily, or as required
TOOLS: Soft Cloth, Soft Bristle Brush
Wipe down the exterior of the Water-Max™ with a soft damp cloth.
Use a soft bristle brush to remove any calcium or lime build-up on the
end of the dispensing nozzle. Wipe dispensing nozzle clean with a soft
damp cloth.
Remove TANK LID.
Wipe TANK FAUCET, interior and exterior of tank with a soft damp
cloth. DO NOT SUBMERGE TANK IN WATER!
Fill tank with cool, clean water. Check operation of faucet.
If the faucet leaks:
Drain tank
Disassemble faucet by unscrewing bonnet from faucet body.
Clean or repair faucet as necessary.
Reassemble bonnet on faucet body.
Reinstall TANK LID.
Drain any remaining water from tank and re-install on Water-Max™.
Press POWER SWITCH to ON (I) and test for proper operation.
Procedure is complete.
CAUTION:
BURN HAZARD
Water in tank is extremely
hot. Use care when draining
tank.
CAUTION:
HOT SURFACES
Exposed surfaces can be hot
to the touch and may cause
burns.
CAUTION:
EQUIPMENT
DAMAGE
DO NOT SUBMERGE TANK
IN WATER!
IMPORTANT:
DO NOT use bleach,
abrasive cleansers or
cleansers containing
chlorides.
HANDLE &
BONNET
FAUCET
BODY
SCREEN
TANK LID
TANK
FAUCET
12