Windsor SPIRIT DUAL SPD-J - Manual (Page 8)

This product contains moving parts.
To reduce the risk of injury; unplug the
machine before servicing.
Maintenance and repairs must be done
by qualified personnel ONLY.
CAUTION:
Using non-Windsor parts to repair this
machine will void the 6-3-1 warranty.
Warranty information is located on the
back of this manual.
Suggested Service Parts List
DESCRIPTION PART NUMBER
Belt 11031
Brush Bearing 09019
Cord Assembly (USA/Japan) 23572
230V Cord Assembly (Europe) 23178
Dome Assembly 28034
Dome Gasket 35060
Hose Cuff. Short Blue 27508
Hose Cuff. Longer Blue 27354
Hose Cuff, White 27079
Jet Assembly 44055
Jet 44061
Jet Seal 44051
Jet Body w/Seal 44052
Manifold Assembly 54094
Pump Service Kit 47176
Screen/Filter, Dome 34140
Screen/Filter, Solution Tank 73250
Solution Release Cable 27665
Solution Release Lever 51200
Switch 72074
230V Switch 72121
Valve 84134
Dailv Maintenance:
These procedures are followed at the end of
each work period to extend the life of the ma-
chine.
1.)
2.)
5.)
6.)
7.)
Empty unused cleaning solution by
disconnecting clear hose on back of
machine and pouring into floor drain.
Inspect and clean solution filter screen
inside tank and vac intake screen
inside dome.
Flush the system. Fill solution tank
with 1 or 2 gallons (4 8 liters) of clean
hot water. With machine over floor
drain turn on vac/pump switch until
solution tank is empty.
Inspect spray pattern of jets.
Remove jets and rinse if clogged.
each use, rinse recovery tank with
fresh water. Periodically inspect the
recovery tank and decontaminate if
necessary, using a Hospital Grade
Virucide or a l-l 0 bleach to water
solution. Waste water should be disposed
of properly.
Remove any lint or debris from brush.
Inspect power cord. Remember, this
cord will lay on a damp surface.
Warning:
IMMEDIATELY REPLACE WORN OR
FRAYED POWER CORDS.
8.) Inspect hoses. Worn or cracked
hoses may cause loss of vac pressure.
9.) Place the brush in the storage
position. Press back slightly on the
main handle, and place the brush
adjustment lever in the
For infrequent use or long periods of stor-
age, flush the system with a neutralizing solution
of 1 quart (1 liter) white vinegar mixed with 2 gal-
lons (8 liters) hot water. Flush the system with
clean hot water after neutralizing.
8