Program menus – Wibur Curtis Company TCTS/T User Manual

Page 2

To Go Into Programming

Turn off (dark display) by pressing ON/OFF button (yellow). Press and hold BREW button 4 (green) and then press and release ON/OFF button (yellow).

Continue holding BREW button. Display will read

, wait until

is displayed Enter the 4-digit access code, the digits 1-4 corre-

spond to the buttons (see illustration below).

The default code set at the factory is 1-2-3-4. Then

will be displayed.

PROGRAM MENUS

WILBUR CURTIS

FILLING

WILBUR CURTIS

HEATING

WILBUR CURTIS

READY TO BREW

All programming selections are performed with the three center buttons.

The symbols below the buttons are:

Scroll LEFT



SELECTION or ENTER to save new parameter

Scroll RIGHT

Brew Volume (Factory set to 3.0 Gallons)

Selecting Brew by Volume or Brew by Time depends on whether you know your brew time before starting.

From Program Menus press > display will now show the next feature.

Recipe Select (Factory set to Standard Tea)

Press  to Select. Press < or > to toggle between STANDARD TEA and TROPICAL TEA. Set and exit by press-

ing .

Brew by Volume: Press  to Select, Display will now show Push START To Begin... Press the BREW button then

hot water starts running, when desired volume is reached press BREW button again to stop the ﬂow. Now the

volume has been set. Pressing > button will display the subsequent menu features.

Brew by Time. Press  to Select to change the brew time. Display will now show the current time. By pressing <

or > you can toggle back and forth from minutes to seconds to exit (ex). Change the time or set and exit by press-

ing . Brew by Time is programmable from 0:00 to 9:59. Increments are minutes and seconds.

Dilution Delay: Press  to Select, Delay Time in minutes (m.) and seconds (s.) will display. Press < or > to

increase or decrease time. Range is from 30 seconds to 10 minutes.

Dilution Volume: Press  to Select, Display will now show Push START To Begin... Press the BREW button then

hot water starts running, when desired volume is reached press BREW button again to stop the ﬂow. Now the

volume has been set. Pressing > button will display the subsequent menu features.

Dilution Time: Press  to Select, Display will now show current setting Time 0:00 and ex (exit) will ﬂash. Press <

or > to toggle between minutes, seconds or exit. Pressing select  to choose minutes will increase the minutes.

Press  to add minutes. Press < or > to move to seconds or exit. Dilution Time is from 0:00 to 9:59. Increments

are minutes and seconds.

Dilution Stir (Factory set to ON).

Press  to Select, press < or > to toggle between ON or OFF. Dilution Stir applies only to the Dilution cycle, by

pulsing the dilution time 45 seconds on, 5 seconds off.

Program Menus

Dilution Volume

Continued on Page 3

Brew By Volume

Dilution Delay

Dilution Time

Dilution Stir

Recipe Select

Brew By Time