weber SUMMIT 41996 - Manual (Page 28)

C-2
Gas Instructions
(1)
(1)
(2)
(2)
a
b
Connect Gas Supply
a) To connect gas hose at the supply: Slide back the
collar of the quick disconnect. Push male fitting of the hose
into the quick disconnect, and maintain pressure(1). Slide
the collar closed(2). If it does not engage or lock, repeat
procedure.
b) To connect gas hose at the Grill: Slide back the collar
of the quick disconnect. Push male fitting of the grill
connection into the quick disconnect, and maintain
pressure(1). Slide the collar closed(2). If it does not
engage or lock, repeat procedure.
Gas will not flow unless the quick disconnect is properly
engaged.
Check for Gas Leaks
ƽ DANGER
Do not use an open flame to check for gas leaks. Be
sure there are no sparks or open flames in the area
while you check for leaks. Sparks or open flames will
result in a fire or explosion which can cause serious
bodily injury or death and damage to property.
ƽ WARNING: You should check for gas leaks every
time you disconnect and reconnect a gas fitting.
ƽ WARNING: Perform these leak checks even if your
barbecue was dealer or store assembled.
Turn on gas supply.
Check for leaks by wetting the connections with the soap
and water solution and watching for bubbles. If bubbles
form or if a bubble grows, there is a leak.
Note - Since some leak test solutions, including soap and
water, may be slightly corrosive, all connections should be
rinsed with water after checking for leaks.
ƽ WARNING: Do not ignite burners when leak
checking.