Whirlpool HD1000XSC7 - Manual (Page 7)

Installation Instructions cont.
7
7.
Position tank vertically beneath
spout so that clear tubing from spout
reaches center stainless tubing on
tank, and tank touches wall. Use a
pencil to mark on the wall where the
top of tank needs to be located. Set
tank aside. Mark a second line 2-1/4"
below the first line.
Position mounting bracket on wall so
that bottom of mounting bracket is
even with the lower line. Use two
screws (and plastic anchors if
attaching to dry wall) to fasten
mounting bracket to wall. Hang tank
on bracket.
5.
Loosen square nut until it is
flush with end of the mounting screw.
Tip spout bracket against mounting
screw. (Bracket will form a “y” when
in the correct position.)
Hold nut, bracket, gasket and tubing
in position and insert into hole in sink
or counter.
mounting
screw
square
nut
bracket
6.
Pull up on spout body to keep
tension on spout mounting bracket
and nut. Tighten screw inside the
spout until spout is securely in
position. Do not overtighten. Snap
on On/Off Cap.
4.
Lay spout assembly on flat
surface with coiled tubing facing up.
Using one hand to hold tubing just
below spout, carefully straighten
tubing with other hand.
Slide gasket over tubing so that lip
side of gasket is seated into base of
spout.
gasket
bracket
2-1/4"
off
position
NOTE: Do NOT plug power supply cord into outlet.