Whirlpool HD1000XSC7 - Manual (Page 6)

Installation Instructions
6
2.
Determine where you will install
your hot water dispenser. Check
below sink to assure that reinforcing
ribs, support brackets or cabinet
construction will not interfere with
spout. Knock out plug from hole in
sink or cut a hole in sink or
countertop.
NOTE: It is recommended that only
a licensed plumber or professional
installer cut an opening in the sink
or countertop.
3.
Remove masking tape and tag
from spout assembly. Do Not remove
quick-connect fittings from spout
tubing or tank tubing. Do not
replace quick-connect fittings with
brass fittings. Brass fittings can cause
lead contamination.
Carefully pull On/Off Cap off the
spout assembly and set aside.
Numbers
correspond
to steps.
2.
3.
7.
8.
9.
10.
11.
16.
12.
4.
5.
5.
13.
14.
15.
6.
clear
tubing
off
position
NOTE: Do NOT plug power supply cord into outlet.
13.
On/Off Cap
1.
Put on gloves and safety glasses.