English – Vitek VT-1684 User Manual

Page 7

Installing the glass tray
1. Install the base for the rotating tray (4) into the opening located in the floor of the cooking chamber.
2. Carefully install the glass tray (5).
• Do not block the rotation of the glass tray during the cooking process.
• During the cooking process, always use the glass tray, rolling ring and tray base.
• Food and cooking dishes must always be placed only on the glass tray.
• The glass tray may rotate clockwise or counter-clockwise. This is normal.
• Replace the tray immediately if it becomes cracked or chipped.

Installation
• Before connecting the microwave oven, make sure that the operating voltage and power usage matches the

parameters of your electrical system. Connect the microwave oven to a grounded electrical outlet.

• Install the oven on a flat, stable surface. Choose a location that will not be accessible to small children.
• Install the oven so that the distance between the wall and the back of the oven is no less than 7-8 cm and the free

space above the microwave is no less than 30 cm.

• Do not remove the legs from the bottom of the microwave oven.
• Do not block the ventilation openings on the microwave oven's housing.
• The microwave oven should be installed away from televisions and radios in order to prevent static interference of

radio and television signals.

WARNING: Do not install the microwave oven on heating surfaces (kitchen stoves) or other sources of heat waves.
If the microwave oven malfunctions due to user error, the warranty for free service and repair is voided.
While operating, the top surface of the microwave oven and heat up significantly; avoid touching hot surfaces of the
oven with bare skin in order to prevent burns.

Using the oven
Audible signal
Each time a button on the control panel is pressed the oven will emit an audible "beep."

Setting the current time
Connect the power plug to the outlet; the microwave will emit a "beep" and the display will show the numbers "1:01."
Press the "ЧАСЫ" button one or two times to choose between the 12 or 24-hour time format.
For example: to set the current time of 8 hours 30 minutes.
1. Press the "ЧАСЫ" button once.
2. Rotate the "ВРЕМЯ/ВЕС" knob clockwise and set the hours to 8.
3. Press the "ЧАСЫ" button again to confirm.
4. Rotate the "ВРЕМЯ/ВЕС" knob clockwise to set the minutes to 30; the display will show the time as 8:30.
5. Press the "ЧАСЫ" button to confirm.
The display will show the set time; the (22) pictogram and the colon (19) will blink.

Note: if you do not complete the time setting process then, after 30 seconds, the microwave will "beep" and the dis-
play will return to its initial setting. To see the current time during the cooking process, just press the "ЧАСЫ" button
and the current time will be displayed for 5 seconds.

Cooking in the microwave oven
To start the oven in microwave mode, press the "МОЩНОСТЬ" button several times to set the desired power level
and then rotate the "ВРЕМЯ/ВЕС" knob clockwise to set the needed cooking time.
The maximum possible cooking time is 60 minutes.

Choose the power level:

ENGLISH

"МОЩНОСТЬ" button pushes

Power level

1 time

100%

2 times

80%

3 times

60%

4 times

40%

5 times

20%

6 times (timer)

1684.indd 7

13.08.2009 14:47:49