White Rodgers 1F97-71 - Manual (Page 21)

21
est heat temperature and the lowest cool tempera-
ture (see diagram below).
2. Determine the time periods during which you
will program the temperatures you have just
selected. You must program four periods for
each day (periods 1, 2, 3, and 4). However,
you may use the same heating and cooling
temperatures for consecutive time periods.
Also keep in mind that, for any given day, you
can only program one set of times for both
heating and cooling (for example, if you select
5:00 AM to begin heating period 1 on Monday,
then your cooling period 1 for Monday will also
begin at 5:00 AM). However, you may choose
Temperature
Designation
Factory
Preprogrammed
Temperature
Your
Selected
Temperatures*
HEAT A
HEAT B
HEAT C
HEAT D
70
70
70
64
COOL A
COOL B
COOL C
COOL D
78
82
78
78
* You may only program heating temperatures you have selected
into the heating program and cooling temperatures into the
cooling program (for example, you cannot program the COOL A
temperature into your heating program). You may program the
temperatures you choose in any order, and you may use the
same temperature in consecutive program periods (for example,
you may program period 1 with temperature B and periods 2, 3,
and 4 with temperature A). You do not have to use all possible
temperature choices (for example, you may want to select
temperatures for HEAT A and HEAT B only – in this case, the
HEAT C and HEAT D temperatures would stay the same as
previously programmed).
79
78
77
76
75
74
73
COOLING TEMPERATURES
HEATING TEMPERATURES
DEAD BAND 1°F