Williams Sound Personal PA Receiver PPA R35-8 - Manual (Page 3)

3 ®
On/Off Switch
Volume Control
Headphone
Jack
"On"/Low Battery
Indicator LED
Channel
Selector Knob
Battery Information
The PPA R35-8 Receiver can use two (2)
disposable AA batteries
(BAT 001) or two (2) AA rechargeable
batteries (BAT 026).
Note: The BAT 026 provides longer life
than other rechargeables. Do not substi-
tute other rechargeable batteries and
chargers.
Low Battery Indicator
The “On” indicator on top of the unit will
flash to indicate low battery.
Recharging
If the R35-8 is equipped with recharge-
able batteries, up to 12 units can be
charged at one time in the optional
CHG 3512 multicharger. Refer to the
MAN 116 charger instruction sheet for
complete charging instructions. For
ordering information, please contact
Williams Sound at 800-843-3544.
Earpad Cleaning
Do not immerse the earphone in water or
other cleaning agent. Foam pads may be
removed and washed with a mild laundry
soap solution, rinsed thoroughly, and air-
dried. You may also opt to purchase new
foam pads. Call the factory for more
information: 800-843-3544.
FIG B: R35-8 Control Panel
2. Plug the earphone or headphone into
the Headphone jack on the receiver’s
control panel.
3. Turn the receiver on by rotating the
Volume control knob. The ON indica-
tor should illuminate RED.
4. Select the channel you’d like by turn-
ing the channel selector on the con-
trol panel. Choose between 8 stan-
dard frequencies: 72.1, 72.3, 72.6,
72.8, 74.7, 75.4, 75.7, or 75.9 MHz.
Important: Make sure the receiver fre-
quency matches the transmitter fre-
quency!
5. Adjust the volume to a comfortable
listening level.
6. To turn the receiver off, rotate the
Volume control knob to the left until
it clicks off. The ON indicator
should not be lit. To prolong the bat-
tery life of the unit, turn the receiver
off when it is not in use.