Weed Eater Twist 'N Edge 600 - Manual (Page 6)

6
NOTE: If shield is not properly installed, dam-
age to unit (including motor failure) will result.
1. Place the shield onto the motor housing.
Ensure the cutting head remains free to
rotate and the line is not caught between
the shield and the motor housing (see fol-
lowing illustration).
Motor Housing
Shield
Line Limiter
Pin
Cutting Head
2. Align the installation arrow on the shield
with the installation arrow on the motor
housing as shown.
Installation
arrows
3. Twist the shield as illustrated until it snaps
securely into place. Make sure the shield
is assembled to the unit as shown in the
illustration below and in the KNOW
YOUR TRIMMER section of this manual.
WHEEL ASSEMBLY
1. Fit the two halves of the wheel together
(see illustration).
Wheel
2. Attach the wheel to the trimmer. Make
sure the wheel is fitted into the groove on
the motor housing.
Groove
Motor
Housing
3. Clip the wheel together securely on the
other side. The wheel should turn freely.
INSTALLATION OF ASSIST HANDLE
1. Press the two buttons on the sides of the
switch handle.
Button
Button
Assist Handle
2. Push the assist handle over the buttons
and release the buttons.
3. Adjust the handle to the most comfortable
operating position by pressing the buttons
and moving the handle.