Weed Eater Twist 'N Edge 600 - Manual (Page 11)

11
Air Vents
S Remove the wheel by pressing one of the
buttons. Clean the wheel and groove on the
motor housing with a soft brush. Reinstall
wheel (see ASSEMBLY section).
Groove
SERVICE AND ADJUSTMENTS
REPLACING THE LINE
WARNING:
Disconnect unit from
power source before servicing.
1. Press and hold in the two cap release
latches.
2. Pull cap away from the hub.
Cap
Cap
release
latch
Spool
Hub
Eyelet
3. Remove old spool.
4. Clean entire surface of hub and spool.
5. Replace with a pre--wound spool or cut
two lengths of 13 feet (4 meters) of 0.065″
(1.65 mm) diameter WEED EATER brand
line. Use of heavier lines could overload
and damage unit.
WARNING: Never use wire, rope,
string, etc., which can break off and become a
dangerous missile.
6. Insert one end of the line about 1/2 inch (1
cm) into one of the small holes in the up-
per section of the inside of the spool.
7. Wind the line evenly and tightly onto the
spool. Wind in the direction of the arrow
found on the spool.
8. Push the line into the notch, leaving 3 to 5
inches (7 -- 12 cm) unwound.
9. Repeat on the lower section of the spool.
Notches