Whirlpool 8ET8MTKXKT00 - Manual (Page 17)

17
To replace the shelf:
NOTE: Make sure that both of the rear shelf slides are
securely in the track before letting go of the shelf. The
lateral shelf may be difficult to install if the track is placed
too close to the refrigerator ceiling. Reposition the track on
a lower rung until the shelf can be tilted enough to easily
slide into the track.
1. Hold the shelf at the front and tip the front at a 45°
angle to the track.
2. Insert both of the rear shelf slides into the upper
channel of the track.
3. Lower the front into place.
Door Rails
The door rails may be removed for easier cleaning.
Snap-on Door Rails
To remove the rails:
1. Remove all items from the shelf.
2. Push in slightly on the front of the bracket while pulling
out on the inside tab.
3. Repeat these steps for the other end of the rail.
To replace the rails:
1. Line up the ends of the brackets with the buttons on
the sides of the door liner.
2. Firmly snap bracket and rail assembly onto the tabs
above the shelf as shown.
Drop-in Door Rails
To remove the rails:
1. Remove all items from the shelf.
2. Pull straight up on each end of the rail.
To replace the rails:
1. Slide the shelf rail into the slots on the door.
2. Push the rail straight down until it stops.
Door Bins
(on some models)
The door bins are removable for easy cleaning and
adjusting.
1. To remove the bin, simply lift the bin up and pull
straight out.
2. To replace the bin, slide it in above the desired
support button and push down until it stops.