Wasp Bar Code WWR2900 - Manual (Page 8)

Chapter 5
6
In order to configure Wasp WWR2900 / 2905 Scanners, you must
familiarize yourself with the setup procedures on the following pages. The
default settings of the scanners are identified on each page and clearly
marked using an asterisk (*). The default settings have been
preprogrammed for the most common barcode configurations. Use the
setup & configuration barcodes only to customize the Wasp WWR2900 /
2905 Scanners settings. If you need to configure the Scanner, the default
settings will be overwritten. All the programmed settings are stored
permanently in non-volatile memory; therefore, your configuration will be
maintained even if the keyboard power to Wasp WWR2900 / 2905
Scanners are removed by turning off your PC.
In order to configure Wasp WWR2900 Series Scanners,
two basic steps need to be followed:
(1) Locate the group that contains the options to be changed.
(2) Scan the barcode representing the option to be changed.
The scanner will sound two beeps.
To change Minimum/Maximum Length:
(1) Scan the Minimum or Maximum Length barcode.
(2) Scan a 2 digit value from the ASCII table on pages 32-35
(3) Scan the Minimum or Maximum Length barcode again.
Setup & Configuration
WWR2900_2905Manual0308_sm.A0 6/25/08 4:43 PM Page 6