Wilson Car Amplifier - Manual (Page 7)

6
Installing the Antenna
To receive the best cell signal, select a window location at least 12 inches away from any
radio or television antennas and free of obstructions.
Using the suction cups, position the
optional mounting bracket on the window at
a height convenient to where the amplifi er
will be located, then attach the antenna to
the bracket.
The antenna must be installed vertically.
Signal performance will be degraded if the
antenna is not vertical.
Select a location to install the amplifi er that
is away from excessive heat, direct sunlight
or moisture and that has proper ventilation.
Recommended installation locations are:
• On a desk or table top
• In a bookshelf
• On the fl oor
Run the cable from the mini magnet-mount
antenna and attach it to the FME-Male
connector labeled “outside antenna” on the
amplifi er.
Attach the universal connector cable to the
extension cable and attach the extension
cable to the FME-Male connector labeled
“Universal Connector” on the amplifi er.
Then attach the universal connector to your
cell phone or data card. (See page 7)
Home/Offi ce Installation
Installing the Wilson SIGNALBOOST™ Amplifi er
Warning: Do not plug in the AC power
supply until the outside antenna and universal
connector cables are attached to the amplifi er.
!
Warning: The antenna used with this
amplifi er must have a separation distance of at
least 11 inches from all persons.
!