Weider WESY39200 - Manual (Page 17)

17
CABLE ASSEMBL
Y
35. Locate the Leg Press Cable (78). Attach the
end of the Leg Press Cable to the Long ÒUÓ-
Bracket (57) with a 1/4Ó Nylon Locknut (2) and
a 1/4Ó Flat Washer (10). Do not completely
tighten the Nylon Locknut. It should be
threaded onto the end of the Cable only a
couple of turns, as shown in the inset
drawing.
Wrap the Leg Press Cable (78) around a
3 1/2Ó Pulley (15). Attach the Pulley to the Leg
Press Upright (56) with the 3/8Ó x 3 3/4Ó Bolt
(88), a 3/8Ó Flat Washer (9), and a 3/8Ó Nylon
Locknut (21). Be sure that the Cable and
Pulley move smoothly and that the Cable
is between the Pulley and the welded rod.
The ball on the Cable must be on the indi-
cated side of the Pulley.
36. Attach the Press Bracket (94) to the Leg
Press Arm (96) with a 3/8Ó x 3Ó Bolt (100) and
a 3/8Ó Nylon Jam Nut (99).
Wrap the Leg Press Cable (78) around a 3 1/2Ó
Pulley (15). Attach the Pulley to the Press
Bracket (94) with a 3/8Ó x 2Ó Bolt (12) and a
3/8Ó Nylon Locknut (21).
Slide a 5/16Ó Flat Washer (8) onto a 5/16Ó x
2 3/4Ó Bolt (11). Insert the Bolt through the
center hole in the Leg Press Seat Frame (79)
from the indicated side. (Note: The three
holes are for cable adjustment.) Tighten a
5/16Ó Flat Washer (8) and a 5/16Ó Nylon Jam
Nut (93) onto the Bolt. Slide the end of the
Leg Press Cable (78) onto the end of the Bolt.
Thread another 5/16Ó Nylon Jam Nut (93)
onto the Bolt. Do not fully tighten the sec-
ond Jam Nut. There must be room
between the two Jam Nuts for the end of
the Cable to pivot.
36
11
100
96
94
12
21
79
93
8
99
78
15
8
35
56
Ball
9
21
15
2
10
88
2
10
57
57
78
78
Welded
Rod