Weider WESY39200 - Manual (Page 14)

14
25. Locate the Low Cable (23) and the bag
labeled ÒLOW PULLEY.Ó Route the Low
Cable under the 3 1/2Ó Low Pulley (76).
Attach the Pulley and the 5/8Ó x 9/16Ó Spacer
(7) to the Press Frame (17) with a 3/8Ó x 3
3/4Ó Bolt (88), 3/8Ó Flat Washer (9), and a 3/8Ó
Nylon Locknut (21). Be sure that the parts
are oriented as shown in the drawing, and
that the end of the Cable with the ball is on
the indicated side of the Press Frame
between the Pulley and the crossbar.
26. Route the Low Cable (23) around a 3 1/2Ó
Pulley (15). Attach Pulley and a Cable Trap
(66) to the lower hole in the Front Upright (42)
with a 3/8Ó x 3 3/4Ó Bolt (88), a 3/8Ó Flat
Washer (9), and a 3/8Ó Nylon Locknut (21).
See the inset drawing. Be sure that the
Cable Trap is turned to hold the Cable in
place and that the Cable is routed around
the Pulley as shown.
27. Route the Low Cable (23) around a 3 1/2Ó
Pulley (15). Attach the Pulley and a Cable
Trap (66) to the upper hole in the Press
Frame (17) with a 3/8Ó x 3 1/2Ó Bolt (16), a
3/8Ó Flat Washer (9), and a 3/8Ó Nylon
Locknut (21). Be sure that the Cable Trap is
turned to hold the Cable in place and that
the Cable is routed around the Pulley as
shown.
28. Route the Low Cable (23) around another 3
1/2Ó Pulley (15). Attach the Pulley and a
Cable Trap (66) to the upper hole in the Front
Upright (42) with a 3/8Ó x 3 3/4Ó Bolt (88), a
3/8Ó Flat Washer (9), and a 3/8Ó Nylon
Locknut (21). See the inset drawing. Be
sure that the Cable Trap is turned to hold
the Cable in place and that the Cable is
routed around the Pulley as shown.
28
27
CABLE ASSEMBL
Y
Inset shows view
from other side
42
88 23
23 15
15
66
42
21
88
9
66
23
17
66
15
9
16
21
21
17
76
7
9
88
23 17
Ball
76
Crossbar
23
88 9
15
42
26
Inset shows view
from other side
42
21
23 15
66
66 21
25