Weider WEEVSY87210 - Manual (Page 9)

9
ARM ASSEMBL
Y
12. Wet the handle of one Press Arm (46) with
soapy water. Slide a 5” Plastic Grip (31) onto
the handle. Press a 1” Round Inner Cap (49)
into the other end of the handle. Press a 1
3/4” Square Inner Cap (44) into the top of the
Press Arm.
Attach the Press Arm (46) to one side of the
Press Frame (17) with two 5/16” x 2 1/2”
Bolts (22) and two 5/16” Nylon Locknuts (3).
Assemble the other Press Arm (46) in the
same manner.
13. Lubricate both axles on the Top Frame (55).
Slide the Right Arm (48) onto the right axle.
Note: Be careful not to confuse the Right
Arm with the Left Arm (47); note the posi-
tion of the “V” Pulley (6) to identify the
Right Arm. Be sure that the upper end of
the Right Arm is behind the indicated
bracket on the Top Frame (55).
Tap two 1” Retainers (69) and a 1” Round
Cover Cap (70) onto the axle. Be sure that
the teeth on the Retainers bend toward the
Cover Cap, as shown in the inset drawing.
Attach the Left Arm (47) in the same manner.
Press 1 3/4” Square Inner Caps (44) into the
lower ends of the Left and Right Arms (47,
48). Wet the lower end of each Arm with
soapy water. Slide a 10” Pad (45) onto the
lower end of each Arm.
13
31
44
49
46
46
22
3
17
47
70
45
69
6
Bracket
12
48
44
70
69
55—Axle
55
Axle–Lubricate
44
45