Weider WEEVSY87210 - Manual (Page 13)

CABLE ASSEMBL
Y
12
3
6
9
58
15
21
66
92
9
17
20
21
2
2
10
58
67
10
57
58
20. Route the Short Cable (58) around the 3 1/2”
Pulley (15) attached to the upper hole in the
Press Frame (17). Be sure that the Cable
Trap (66) is in the “3 o’clock” position and
that the Cable is routed around the Pulley
as shown. Tighten the 3/8” Nylon Locknut
(21) and the 3/8” x 3 3/4” Bolt (not shown).
If the indicated 3 1/2” Pulley (15) is pre-
attached to the Front Upright (42), remove it.
Route the Short Cable (58) around the 3 1/2”
Pulley. Attach the Pulley and two Pulley
Covers (89) to the upper hole in the Front
Upright with the 3/8” Nylon Jam Nut (92), the
3/8” Washer (9) and the 3/8” x 3 3/4” Bolt
(71). Be sure that the Cable is routed
around the Pulley as shown.
21. Attach the end of the Short Cable (58) to the
Long “U”-Bracket (57) with a 1/4” Nylon Lock-
nut (2) and a 1/4” Washer (10). Do not com-
pletely tighten the Nylon Locknut. It
should be threaded onto the end of the
Cable so only a couple of threads are
showing above the Nylon Locknut, as
shown in the inset drawing.
13
42
71
89