Weider WESY85070 - Manual (Page 13)

13
23. Attach the 5/16Ó x 3 1/2Ó Bolt (87), two 5/16Ó Flat
Washers (8), the 1Ó Metal Spacer (22), and a 5/16Ó
Nylon Locknut (3) to the Front Upright as shown.
Wrap the Short Cable (23) around a 3 1/2Ó Pulley
(15). Attach the Pulley to the Front Upright (42) with
a 3/8Ó x 3 1/2Ó Bolt (16), a 3/8Ó Washer (9), and a
3/8Ó Nylon Jam Nut (5). Be sure that the Short
Cable is between the Pulley and the Metal
Spacer.
24. Attach the Backrest (41) to the Front Upright (42)
with two 1/4Ó x 2 1/2Ó Screws (43) and 1/4Ó Flat
Washers (10).
25. Press a 1 1/2Ó Square Inner Cap (32) into the Seat
Frame (36).
Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the center
hole in the Seat Plate (37). Attach the Seat Plate to
the Seat (13) with two 1/4Ó x 3/4Ó Screws (18).
Insert the 1/4Ó x 2Ó Carriage Bolt (38) into the indi-
cated hole in the Seat Frame (36). Tighten a 1/4Ó
Nylon Locknut (7) with a 1/4Ó Flat Washer (10) onto
the Carriage Bolt.
Attach the other end of the Seat (13) to the Seat
Frame (36) with a 1/4Ó Flat Washer (10) and the
1/4Ó x 2Ó Screw (20).
24
23
25
36
32
7
13
38
37
18
42
43
10
41
42
9
3
15
16
87
8
22
23
5
8
10
20