Whirlpool MAYTAG W10101293A - Manual (Page 2)

2
INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation.
Read and follow the instructions provided with any tools listed
here.
Tools Required
Parts Supplied
Location Requirements
Your laundry tower can be installed freestanding or between your
washer and dryer. Proper installation is your responsibility.
Installation Clearances
■ The location must be large enough to allow the drawers to be
fully opened.
■ When you are installing your laundry tower between or next to
your washer and dryer, a spacing of 1" (2.5 cm) on the sides of
the laundry tower is recommended to reduce noise transfer.
■ Additional spacing should be considered for ease of
installation and servicing.
Laundry Tower Dimensions
*Includes leveling feet
**Includes drawer front
INSTALLATION INSTRUCTIONS
Install the Console (optional)
1. Using two or more people, situate the laundry tower near its
final location. Open the drawers to remove any contents
stored inside.
2. Using a Phillips screwdriver, remove the 2 outside screws
from the back of the laundry tower top panel and discard
them.
■ Phillips screwdriver
■
⁹⁄₁₆" (14 mm) open-end
wrench (for leveling leg
locknuts)
■ Level
■ Measuring tape
■ Console
■ Screws (2)
■ Brackets (2)
A. Console
B. Bracket
A B
36"*
(91.4 cm)
25
¹⁄₈
"**
(63.8 cm)
13
¹⁄₂
"
(34.3 cm)
38
⁵⁄₈
"*
(98.1 cm)
42
⁷⁄₈
"
(108.8 cm)
WARNING
Excessive Weight Hazard
Use two or more people to move and install
laundry tower.
Failure to do so can result in back or other injury.
A. Outside screws
A