Wayne-Dalton Wireless Wall Station - Manual (Page 2)

Please Do Not Return This Product To The Store. Call Us Directly! Our Trained Technicians Will Answer Your Questions and/or Ship Any Parts You May Need
You can reach us Toll Free at 1-888-827-3667 for Consumer Assistance or online at www.wayne-dalton.com
29
Customizing the Settings
Custom pet position:
The pet button opens a closed door to a preset position between 5 and
30 inches above the floor, allowing pets to enter and exit the garage
without the door being fully open. To change the automatic pet opening
height:
Start with the door in the closed position.
1. Operate the door then stop it at the desired height. If desired
height is not achieved, the door must be returned to the closed
position.
2. Press and release the wall stations program button, or the
opener program switch button two times. The status light on the
opener unit and the overhead light will flash on and off at a
normal rate.
3. Press the pet button. The status light on the opener and the
overhead light will flash on and off three times indicating
successful programming.
M ulti-Door Programming:
Momentarily pressing the button programmed in the transmitter
programming step activates the door. Other buttons can also be
programmed to activate different doors, for multi-door installations.
Each button or a combination of two buttons pressed simultaneously
can be programmed to activate a different door. Only one button at a
time can be programmed to activate a specific opener.
Program Button
Up/Down Button
I
Opener Controls
I
F
O
R
C
E
A
D
J
.
S
T
A
T
U
S
S
W P
R
O
G
R
A
M
Program Status
LED
Program
Button
Right Side Of Opener
The program button located on the right side of the opener has several
functions.
1. Pressing the program button once, will make the status
light and overhead lamp turn on steady. This mode allows
programming of transmitters, wireless keyless entry, and wireless
wall stations (see page 33).
2. Pressing the program button two times will make the
status light and overhead lamp blink on and off. This mode allows
programming of a custom pet position (see “Customizing The
Settings” above).
3. Pressing the program button three times will make the
status light and overhead lamp blink on and off with a long pause
at each blink cycle. This mode allows programming of the opening
force (see page 32).
4. Pressing and holding the program button for 10 seconds
will erase all transmitters, multi-function wall station and wireless
keyless entry from memory. The status light and over
head light will blink 3 times indicating a successful erase operation.
Closing
Force
Bottom Of Opener