Western Telematic NPS-2HD User Manual
Page 12
4. Configure Network Port: In order to allow
communication with the NPS-2HD via the Network Port,
you must first define the IP Address, Subnet Mask, and
Gateway Address. At the NPS command prompt, type /N
and press [Enter] to display the Network Parameters
menu.
a) Settings for network parameters will depend on the
configuration of your individual network. Please
contact your network administrator in order to
determine the appropriate settings for the IP Address,
Subnet Mask, and Gateway Address.
b) To assign network parameters, key in the number for
the desired parameter, press [Enter], and then follow
the instructions in the resulting submenu. For
example, to define the IP Address, type 1 and
press [Enter].
3-2
NPS-2HD Heavy Duty Network Power Switch; User's Guide
Network Power Switch v1.00
Site: WESTERN TELEMATIC, INC.
Commands:
Display
/H
Display this Help Screen
/S[P]
Display Plug Status, [P] with Passwords
Configuration
/G
View/Set General Parameters
/P [n]
View/Set Plug Parameters
/N
View/Set Network Parameters
/DL
Download Configuration to File
Control
+------------------------------------+
/D
Set Plugs to Default Settings | [n] = Optional Plug Name or Number |
/Boot
|
/On
Turn On Plug n
| n+n = Plug n and Plug n
|
/Off
| n:n = Plug n through Plug n
|
/T
Reset Network Interface
| * = All Plugs with Access
|
/R
Relogin as Different User
+------------------------------------+
/X
Exit/Disconnect
TPS>
Figure 3.1: The System Help Screen