Weider Pro 260 831.15609.0 - Manual (Page 7)

7
6. Orient the Backrest (13) as shown. Attach the
Backrest to the Backrest Frames (12) with four
M6 x 40mm Bolts (49) and four M6 Washers (48).
Do not tighten the Bolts.
8. Orient the Seat (14) as shown. Attach the Seat to
the Bench Frame (1) with four M6 x 16mm
Screws (39).
7. Insert the Backrest Bracket (10) through the
Bench Frame (1).
Grease an M10 x 168mm Bolt (50). Attach the
Backrest Frames (12) to the Bench Frame (1)
with the Bolt and an M10 Nylon Locknut (43).
Do
not overtighten the Locknut; the Backrest
Frames must be able to pivot easily.
Attach the Adjustment Pin (25) to the Bench
Frame (1) with an M4 x 16mm Screw (45).
Engage the Pin into the Bench Frame and the
Backrest Bracket (10).
Tighten the M6 x 40mm Bolts (49) and M6
Nylon Locknuts (51) used in steps 5 and 6.
12
10
43
50
25
45 1
8
39
1
Wide
End
14
13
Wide
End
12
48
49
12
7
49
48
48
6