Whirlpool AD35DSS0 - Manual (Page 7)

7
2. Remove bucket.
3. Attach a garden hose to drain hose connector on the inside of
the dehumidifier. Hand tighten.
4. Place the other end of garden hose into a floor drain. Check
to see that the hose lies flat and is in the drain.
5. Reinstall bucket.
NOTES:
■ To use the bucket without the garden hose, remove the
garden hose. Then reinstall bucket.
■ The bucket must be installed and properly aligned for the
dehumidifier to operate with or without a garden hose
connected.
Normal Sounds
When your dehumidifier is operating normally, you may hear
sounds such as:
■ Compressor sounds, which may be loud. This is normal.
■ Clicking sounds when the dehumidifier or compressor turns
off and on, and when the Automatic Shutoff Switch is
working.
■ Air movement from the fan.
DEHUMIDIFIER CARE
Your new dehumidifier is designed to give you many years of dependable service. This section tells you how to clean and care for your
dehumidifier. Call your local authorized dealer for an annual cleaning of the dehumidifier.
Cleaning the Air Filter (on some models)
The air filter is removable for easy cleaning. A clean filter helps
remove dust, lint, and other particles from the air and is important
for best operating efficiency. Check the filter every 2 weeks to
see whether it needs cleaning.
1. Turn off dehumidifier.
2. Remove bucket.
3. Pull filter down from below front louvers.
4. Pull bottom edge of air filter toward you to clear the bottom of
the dehumidifier.
5. Use a vacuum cleaner to clean air filter. If air filter is very dirty,
wash it in warm water with a mild detergent. Do not wash air
filter in the dishwasher or use any chemical cleaners. Air dry
filter completely before replacing to ensure maximum
efficiency.
6. Slide air filter up into the dehumidifier.
7. Reinstall bucket.
8. Turn on the dehumidifier.
A. Garden hose
B. Drain hose connector
B
A