Whirlpool AD35DSS0 - Manual (Page 5)

5
Setting the Controls (Control type 3 only)
Starting/Stopping the Dehumidifier
NOTES:
■ Before turning on the dehumidifier, be sure that the bucket is
empty and fits all the way into the dehumidifier.
■ Each time you unplug the dehumidifier or power is
interrupted, the control will return to your previous settings
when power is restored.
Control Type 3
NOTE: Minimum operating temperature is 38ºF (3ºC).
1. Plug into a grounded 3 prong outlet.
2. Press POWER to turn on dehumidifier.
IMPORTANT: If the Empty/Adjust Bucket light comes on, the
dehumidifier will not operate. Empty or adjust bucket.
3. Press POWER to turn off dehumidifier.
NOTE: The dehumidifier will retain your last settings.
Empty/Adjust Bucket Light
If this light is on, the dehumidifier is not running. This light
indicates that you need to check:
■ If the bucket is full, empty and reinstall bucket.
■ If the bucket is not in position, remove the bucket and
reinstall. Make sure the bucket fits all the way into the
dehumidifier and the light is off, or dehumidifier will not run.
Fan Speed (Control Type 3 Models Only)
1. Press FAN to select fan speed.
2. Choose Low, High or Auto.
■ Low—Will reach the desired humidity setting slower with
lower sound level.
■ High—Will reach the desired humidity setting faster.
■ Auto —Will provide the maximum humidity control by
automatically adjusting the fan speed and/or turning the
dehumidifier on and off to maintain humidity setting.
Desired Humidity (Control Type 3 Models Only)
1. Press DESIRED HUMIDITY to select the desired humidity
setting.
2. Choose Normal, Dry, Max Dry or Continuous Run.
■ Normal—Will operate the dehumidifier at the selected fan
speed until the humidity levels are lowered.
■ Dry—Will operate the dehumidifier at the selected fan
speed until the humidity levels are lowered more than the
Normal setting.
■ Max Dry—Will operate the dehumidifier at the selected
fan speed until the humidity levels are lowered to the
maximum level.
■ Continuous Run—Will operate the dehumidifier
continuously at the selected fan speed regardless of
humidity level. The dehumidifier will turn off only if the
bucket is full or removed.
NOTE: The electronic control will cycle the compressor
on and off if a low temperature condition exists.
Pressing the Desired Humidity arrow will not increase
or decrease the amount of moisture removed during a
low temperature condition. Normal compressor operation
will resume when the low temperature condition no
longer exists.
A. Light glows, indicating the bucket is full or is not in correct position.
B. Adjusts amount of moisture removed from room.
C. Selects fan speed.
A
B
C
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING