Wells WPP-10 - Manual (Page 6)

INSTALLATION
NOTE: DO NOT discard
the carton or other packing
materials until you have
inspected the appliance for
hidden damage and tested it
for proper operation.
Refer to SHIPPING DAMAGE
CLAIM PROCEDURE on the
inside front cover of this
manual.
CAUTION:
RISK OF
DAMAGE
DO NOT connect or energize
this appliance until all
installation instructions are
read and followed. Damage
to the appliance will result if
these instructions are not
followed.
CAUTION:
SHOCK HAZARD
This appliance must be
plugged into a properly
installed and grounded
electrical receptacle.
IMPORTANT:
If an appropriate electrical
receptacle is not readily
accessible, contact a licensed
electrician to install the
appropriate electrical
receptacle.
240 volt units are shipped
without a power plug. Contact
a licensed electrician to install
a power plug appropriate to
local electrical codes.
IMPORTANT:
Damage due to being
connected to the wrong
voltage or phase is NOT
covered by warranty.
UNPACKING & INSPECTION
Carefully remove the appliance from the carton. Remove all
protective plastic film, packing materials and accessories from the
appliance before connecting electrical power or otherwise performing
any installation procedure.
Carefully read all instructions in this manual and the Installation
Instruction Sheet packed with the appliance before starting any
installation.
Read and understand all labels and diagrams attached to the
appliance.
Carefully account for all components and accessories before
discarding packing materials. Store all accessories in a convenient
place for later use.
COMPONENTS:
Tray
Drop Door
Heat Lamp and Heat Lamp Guard
Kettle Assembly and Kettle Lid
Stirrer Wand and Stirrer Collar
Scoop and (2) Ladles
SETUP
Setup the appliance only on a firm, level, non-combustible surface.
Verify local codes for requirements. Concrete, tile, terrazzo or metal
surfaces are recommended. Metal over combustible material may not
meet code for non-combustible surfaces.
Verify that the unit sits firmly ON ALL FOUR LEGS. With a spirit level,
check that the appliance is level front-to-back and side-to-side. With
the adjustable legs, adjust as required to level the appliance. All four
legs must be adjusted to firmly contact the floor in order to prevent
tipping.
Avoid storing flammable or combustible materials in, on or near the
appliance.
ASSEMBLY
Slide kettle lid over stirrer shaft and lid guide. The handle should be
toward the door opening. Slide the lid up until it is captured by the
magnetic holder.
Slide the stirrer collar over the stirrer shaft. Thread the stirrer wand
through the slot in the shaft, then allow the collar to drop into place.
Position kettle vertically with the knob down and to the right side.
Attach kettle to the two hangers. Allow kettle to rotate horizontal.
Connect the kettle electrical pigtail to the twist-lock receptacle.
Thread the heat lamp into the heat lamp socket. Install the heat lamp
guard.
Install the drop door and crumb tray.
4
232 30622
3
Ow
ners
M
a
nual
W
PP-
Se
ries
P
opcorn
Popp
er