Wacom Cintiq DTZ-1200W - Manual (Page 54)

Appendix
Page 52
USING A MOUNTING FIXTURE
Attaching to a fixture:
1. Turn off your computer and power off Cintiq. Disconnect the power cable from the converter unit,
and then the Cintiq cable from the converter unit.
2. Close the Cintiq stand and place the unit face down on a flat, soft surface (such as a cloth spread
across a desktop).
3. Firmly attach Cintiq to the fixture using four M4 Regular screws (4 mm diameter with 0.7 mm pitch).
Important: Make sure the screw clearance depth does not exceed 6 mm, or the screws will
damage the Cintiq.
4. Reattach the Cintiq cable to the converter unit.
Removal from the fixture:
To remove the fixture at a later time, reverse the above steps.
Cintiq can be attached to any mounting fixture
conforming to the VESA 75 standard. This
requires four M4 Regular screws (4 mm
diameter with 0.7 mm pitch) with a clearance
depth of no more than 6 mm.
Exceeding the screw length may result in
damage to the display.
C AUTION When attaching Cintiq onto a VESA standard fixture, be sure to follow all instructions
in the documentation supplied by the fixture manufacturer. If improperly secured, the
unit could fall, resulting in damage to the unit or physical injury.
12WX_Manual.fm Page 52 Thursday, September 20, 2007 3:49 PM