Wind Crest WER364SH - Manual (Page 2)

Copyright 2006 Wind Crest by CNP Industries 2
Install Quick Specs are for planning purposes only. Please refer to the detailed installation instructions, prior to
making any cutouts
.
Wall Mounted Hoods – Install Quick Specs
WER Series Hoods - 24” Depth (cont.)
Maximum Power Supply Required*
15 Amps @ 120 V AC, 60 Hz
20 Amps @ 120 V AC, 60 Hz (when used with
VEN150E remote ventilator)
*Electrical rating is maximum required for any
combination of ventilator, lighting and heat
lamps.
Outdoor Electrical Requirements
Damp outdoor installations require a fault
interrupter circuit connection.
Hood Lighting Rating
• 36” to 48” widths: 100 watts w/halogen
lights or 600 watts w/halogen + heat lamps
• 60” width: 200 watts w/halogen lights
or 700 watts w/halogen + heat lamps
Ventilator Options
640 CFM, Internal Blower: VEN060I**
1000 CFM, Remote Blower: VEN100E
1500 CFM, Remote Blower: VEN150E
Ventilator Motor Ratings
VEN060I: 2.8 Amps @ 120 V AC, 60 Hz**
VEN100E: 8 Amps @ 120 V AC, 60 Hz
VEN150E: 12 Amps @ 120 V AC, 60 Hz
**Two VEN060I internal ventilators can be installed
in WER 60” wide hood. This installation requires
part #10220 dual wire harness. Refer to installation
instructions for full details.
Ventilator Dimensions & Accessory
Transitions (see Ventilator section)
CUSTOMER SPECIFICATION:
Hood Width Specified & finish:
(e.g.WER364S)
Add Keep Hot Lamps: (e.g. WER364SH)
Accessories Selected: (e.g. Back splash with
racks, chrome or brass rails, canopy
extensions)
= w
idth
of
6", 12"
12"
hoo
d to
p
Center Support
48, 60" Models
Chrome/Brass
Rolled Pot Rail
1-7/8"
3/4"
Final Hood Model Selected:
Add Any Accessories:
Specify Ventilator Selected & Transitions:
_____________________________________
“EC” Canopy Extensions (6” or 12” height) for WER hoods