Westinghouse WST3033 - Manual (Page 7)

Before Using For The First Time
1. Carefully unpack your Toaster and
remove all packaging materials. Remove
any labels from the outer stainless steel
surfaces.
2. To remove any dust that may have
accumulated during packaging, simply
wipe the Toaster exterior with a clean,
damp cloth.
3. Do not use abrasive cleansers.
4. Do not put the Toaster, cord or plug in
water.
5. Before making toast for the first time,
operate both pairs of the Toasting Slots
without bread and with both Browning
Selectors set at the maximum setting.
This will help to burn off any dust etc.
which may have accumulated on the
elements. The new elements may give
off an unpleasant smell but this should
not be a cause for alarm. Make sure the
room is well ventilated while doing this.
To Operate Toaster
1. Position the Toaster on a firm, level,
heat-resistant surface, clear of curtains,
draperies, and other combustible
materials.
WARNING: Do not place the Toaster on or
near items that may become
damaged even by moderate
sources of heat.
2. Unwrap power cord from Cord Storage
Wrap on the underside of the Toaster.
3. Plug the power cord into a 120V AC
electrical outlet.
5 6
Toasting Bread
1. Center the bread in the Toasting Slots.
2. Set one or both of the Browning Selectors
to the degree of browning required.
NOTE: The Browning Control is
electronic–moving the Browning
Selector(s) after toasting has started
will not change the degree of
browning.
3. Press one or both of the Toasting
Levers down fully–the Lever(s) will not
lock down unless the Toaster is plugged
in to an electrical outlet. Each Toasting
Lever operates one pair of Toasting
Slots.
The CANCEL Light(s) will illuminate,
and will stay on until the toasting cycle
is stopped, either automatically, when
the toast is ready, or manually, if you
press the CANCEL Button(s).
4. When using only one of the Toasting
Slots in a pair, do not allow anything to
enter the other Slot, as both Slots will
be heating when the Lever is lowered.
5. When the toasting cycle is completed,
the toast will pop up.
6. EXTRA LIFT: When toasting small items
(bagels, crumpets, etc.) the Toasting
Lever(s) may be raised further, to allow
them to be removed more easily.
NOTE: Do not operate the Toaster unless
both Crumb Trays are in position and
correctly fitted.
Cancel Buttons
There are 2 CANCEL Buttons, one for each
pair of Slots.
If you wish to stop the toasting cycle before
it is complete, press the appropriate
CANCEL Button. The elements will be
turned off, the toast will pop up, and the
CANCEL Light(s) will go out.
Reheating Toast
This Toaster has a special setting for
reheating toast, which overrides the
Browning Selector(s).
To reheat toast which has cooled, place it in
one of the toasting slots, lower the
Toasting Lever, then press the REHEAT
Button. The REHEAT Light will illuminate, to
show that this feature is operating, and the
toast will be given a short burst of heat
before popping up.
NOTE: The REHEAT Button affects all four
Slots. You CANNOT program the
Toaster to REHEAT toast and make
fresh toast at the same time.
CAUTION: Only reheat plain, unbuttered
toast.
Frozen Bread
Leave the Browning Selector(s) at its
normal setting, place the frozen bread into
the toasting slots, lower the Toasting Lever,
then press the FROZEN Button. The
FROZEN Light will illuminate, and will stay
on until toasting is complete.
The toasting time will be altered
automatically to give the same degree of
browning you get with unfrozen bread.
NOTE: The FROZEN Button affects all four
Slots. You CANNOT program the
Toaster to toast FROZEN bread and
unfrozen bread at the same time.
Control Panel
OPERATING INSTRUCTIONS
Lights
Buttons