Vision Fitness ST720 - Manual (Page 16)

16
6
STEP
• Attach the swing arm (AF1) to swing
arm support (AC3) by guiding the small
axle (FO8) through the bracket on the
swing arm support. Once through the wall
of the bracket, slide a wavy washer
(20.7x29.1x0.3) over the axle, before
sliding the axle through the swing arm
(AF1). After exiting the opposite wall of the
bracket (make sure to line the flat surface of
the axle up with the flat on the bracket)
attach a bushing (F10), flat washer
(13x26x2.5), lock washer (12.2x21.5x3),
and bolt (M12x25). Tighten hardware.
• Place the press arm (AD1) over the
swing arm (AF1) and fasten by sliding a
shaft (DO1) through (match up flat surfaces)
and attach with a bushing (DO7), flat
washer (13x26x2.5), lock washer
(12.2x21.5x3), and bolt (M12x25).
Tighten hardware.
YELLOW BAG