VIEWSONIC VX510 - Manual (Page 5)

Quick Installation
1 Remove two rear panel covers
3 Connect video cable
• Make sure both the LCD display and
computer are turned OFF
• Connect the video cable from the LCD
display to the computer
Macintosh users: Models older than G3
require a Macintosh adapter. Attach the
adapter to the computer and plug the video
cable into the adapter.
To order a ViewSonic ® Macintosh adapter,
contact ViewSonic Customer Support.
4 Turn ON LCD display and
computer
Turn ON the LCD display, then turn ON the
computer. This sequence (LCD display
before computer) is important.
NOTE: Windows users may receive a
message asking them to install the INF file.
This is on the CD.
5 Insert the ViewSonic Wizard CD
into the computer’s CD drive.
Follow the on-screen instructions
If your computer does not have a CD-ROM
drive, see “Customer Support.”
(1) Wait for the CD-ROM to auto-start.
NOTE: If the CD-ROM does not auto-start:
double-click on the CD-ROM icon in the
Windows Explorer, then double-click on
viewsonic.exe.
5 Wizard CD (continued)
(2) Follow the on-screen instructions.
6 Windows users: Set the timing
mode (resolution and refresh
rate)
Example: 1 024 x 768 @ 60 Hz.
For instructions on changing the resolution
and refresh rate, see the graphic card’s user
guide.
Installation is complete. Enjoy your new
ViewSonic LCD display.
To be best prepared for any future customer
service needs: print this user guide and write
the serial number in “For Your Records” on
page 2. (See back of LCD display.)
You can register your product online at the
website for your region. See the Customer
Support table in this guide.
The ViewSonic Wizard CD-ROM also
provides an opportunity for you to print the
registration form which you may mail or fax
to ViewSonic.
ViewSonic VX510 4
2
Connect power cord
Power cord
Rear panel
covers
AC outlet
(wall socket)
Computer
power cord
AC IN
D-SUB