Vizio TL-WR641G - Manual (Page 64)

TL-WR641G 108M Wireless Router User Guide
- 56 -
) Note:
An item could not be loaded to the IP & MAC Binding list if the IP address of the item has been
loaded before. Error warning will prompt as well. Likewise, "Load All" only loads the items without
interference to the IP & MAC Binding list.
4.10 Static Routing
A static route is a pre-determined path that network information must travel to reach a specific
host or network. To add or delete a route, work in the area under the Static Routing page
(shown in Figure 4-54).
Figure 4-54
To add static routing entries:
1. Click the Add New button. (pop-up Figure 4-54)
2. Enter the following data:
¾ Destination IP Address - The Destination IP Address is the address of the network or
host that you want to assign to a static route.
¾ Subnet Mask - The Subnet Mask determines which portion of an IP Address is the
network portion, and which portion is the host portion.
¾ Gateway - This is the IP Address of the gateway device that allows for contact between the
router and the network or host.
3. Select Enabled or Disabled for this entry on the Status pull-down list.
4. Click the Save button to save it.
Figure 4-55