Varec 4000 User Manual
Page 27

17
4000
Configuration
3.4.3
Configuration Menu
Configuration Menu
Description
Level Units
Level units used for display and Modbus data. FT-IN-16TH, M,
or FT are valid. Use F1/F2 to select.
Temp Units
Temperature units used for display and Modbus data. F, C, or K
are valid. Use F1/F2 to select.
Level Sensor
Direction of gauge. Forward/Reverse
Calib Level2
Command used to calibrate to a new level. Pressing F4 causes
ATT to ask for the current level to be entered.
Batt Off2
Command used to turn the battery off. Pressing F4 causes the
battery to be turned off.
Damping
Damping value used for level and temperature readings. 0-16
is valid.
Temp Sensor
Type of temperature sensor attached. None, Copper RTD, or
Platinum RTD are valid. Use F1/F2 to select.
Manual Temperature
If there is no temperature sensor, this is the value displayed
and returned for temperature.
Noise Reject
Sets up the noise rejection for the A/D. 50 and 60 Hz are valid.
Use F1/F2 to select.
Critical High Level
Critical high level alarm setpoint.
Advisory High Level
Advisory high level alarm setpoint.
Advisory Low Level
Advisory Low LevelAdvisory low level alarm setpoint.
Critical Low Level
Critical low level alarm setpoint.
Level Deadband
Deadband used for level alarms.
Critical High Temp
Critical high temperature alarm setpoint.
Advisory High Temp
Advisory high temperature alarm setpoint.
Advisory Low Temp
Advisory low temperature alarm setpoint.
Critical Low Temp
Critical low temperature alarm setpoint.
Temp Deadband
Deadband used for temperature alarms.