VIEWSONIC VNB100 Netbook VS12570 - Manual (Page 17)

ViewSonic VNB100
8
5. Getting Started
5-1 Install the Rechargeable Battery
Power the Notebook PC before using it. There are two ways to power the Notebook PC: Use
the AC Adapter to power it or use the removable Battery Pack.
The Notebook PC is designed to work with a removable Battery Pack. Your Notebook PC
may or may not have its Battery Pack installed. If your Notebook PC does not have its Battery
Pack installed, using the following procedures to install the Battery Pack:
Push the Battery Pack toward the arrow into the Notebook PC until you hear it click and lock
into place.
5-2 Remove the Battery Pack
1. Turn off the Notebook PC，and disconnect all lines.
2. Shut down and turn over the computer to access its base in flat and clean work surface.
3. Slide the Battery Latch toward the arrow ①.
4. Draw the Battery Pack towards the arrow ② to release the Battery Pack from the
Notebook PC.
WARNING! For safety reasons, DO NOT disassemble the Battery Pack, DO NOT
short the circuit, DO NOT throw the Battery Pack into fire and keep it away from
children.
When the Notebook PC with Battery Pack (disconnect the adapter) turns on, the
Power Indicator will turn on. And the light will turn off when in standby mode or
system halting.
DO NOT attempt to remove the Battery Pack while the Notebook PC turns on, as this
may result in the loss of working data.
Damage may occur if you use a different adapter to power the Notebook PC or use
the Notebook PC’s adapter to power other electrical devices.