Viking 450 - Manual (Page 7)

Features: Cycles
P
ro
d
u
ct
C
o
n
tr
o
ls
13
Features: Cycles
P
ro
d
u
ct
C
o
n
tr
o
ls
12
Cycles Options
450
Wash Cycles
Pots/Pans
Heavily soiled pots, pans and casserole dishes. Long heated prewash
loosens up encrusted food. High temperature and intense pressure long
main wash. High temperature rinse.
Normal Wash
Normally soiled plates, glasses, bowls, and lightly soiled pots and pans.
Normal prewash, main wash and rinse. Medium pressure and temperature.
Econo Wash
Normally soiled plates, glasses, bowls, and lightly soiled pots and pans.
Lower temperature main wash and rinse. Longer prewash and main wash to
maximize cleaning performance while using less energy.
Light/China
Lightly soiled dishes or fine china and crystal. Low temperature wash and
rinse. Lightest pressure to protect dishes.
Rinse/Hold
All dishware. Short, medium pressure rinse with no heat.
Options
Top Wash Only
Washes dishes on top rack only. Conserves energy. Available on
Normal Cycle.
Econo Dry
Selects a “no heat” dry. Available on Normal, Econo Wash and Light
China Cycles.
155° F (68° C) Final Rinse
Increases the temperature of final rinse to 155° F (68° C). Available on
Pots and Pans and Normal Cycle.
Delay Start
Lets you delay running the dishwasher for up to 10 hours. To set “Delay
Start”, select the desired wash cycle and option(s). Press the “Delay
Start” button once and the number “2” will light, indicating a two hour
delay. If you desire a longer delay, continue pressing the “Delay Start”
button to a 4, 6, 8 or 10 hour delay. The corresponding number on the
button will light. Once you have set the desired delay time, press the
“START” button and close the door. “Delay Start” is not available with
the Rinse/Hold cycle.
Audible Sound Signal (select models)
A single beep will occur when you select cycles, options and press the
“START” key. The end-of-cycle signal consists of 2 long beeps. If the
“START” button is not pressed or if the door is not closed within 4
seconds of pressing the “START” button, 3 short beeps will occur. For
all other error messages and to deselect the audible sound signal, see
the Troubleshooting/Fault Codes section.