VIEWSONIC N2060W - Manual (Page 13)

Sound Setup (Same for all modes)
1. The range of adjusting volume, bass and treble is from 0~100.
2. Select “ON” or “OFF” in Audio selection to control the sound output.
3. The range of adjusting Balance is -50~+50; when adjusting from 0 to -50,
the sound from the right track fades until silence; when adjusting from 0 to
+50, the sound from the left track fades until silence.
4. AVL: you can set it “ON” or “OFF”.
The function is to adjust the input sound automatically. You may enable
this function when you notice that the sound in the two tracks are very
different, in order to prevent the bad sound effect result from large sound
variation.
5. Select "ON" or "OFF" for Loudness: a default setting is preset, you may
adjust when necessary.
The following menu will appear when selecting continuously:
6. Audio mode: Designed for the different types of sound output, wherein, the
dialogue, music and theater modes are preset; you can set Bass, Treble
and Equalizer in sound output mode according to your preference.
7. Equalizer: You can select and adjust the 100, 300, 1K, 3K and 8K
respectively (the figures represent the sound frequency range).
8. Reset To Default: Reset the sound setting to the factory default value.
ViewSonic 11 N2060w