Vinotemp WINE-MATE VINO2500HZD - Manual (Page 7)

- 6 -
2. WM-1500~2500HZD cabinet installation
• Cut a rectangular inside opening with the 1/4” clearance inwards to the width
and height of the cooling unit. By not going through, leave 1/2” lip inside at the
wall to place the gaskets (see Fig 2.1).
• If top exhaust installation, cut another rectangular opening at the top of the
cabinet to the length and width of the top exhaust.
• Install 2 pieces of 1/4” ID wood thread inserts at the ceiling (see Fig.2.1 & 2.2).
• Place the gaskets (1/2” foam tape) on the mounting lip sides (see Fig 2.3).
• If top exhaust installation, place another gaskets along the top exhaust at the
top of the cooling unit (see Fig.2.4).
• Move the cooling unit towards the mounting sides and push to press the
gaskets (see Fig 2.5).
• Use 2 brackets and ¼” screws with 7/16” wrench to secure the cooling unit
(see Fig 2.6).
• Install the cabinet grille on the cabinet exterior wall (see Fig. 2.7).
• Plug the cooling unit in the cabinet receptacle.
• Plug the wine cabinet.
Fig. 2.1 CABINET CUTOUT & GASKET LIP