Headset operation, Belt clip – VTech 20-2432 User Manual

Page 40

Headset Operation

Your 20-2432

20-2432

20-2432 Handset is equipped with a 2.5mm Headset Jack for use with

an optional accessory Headset for hands-free operation. If you choose to use

the Headset option, you must obtain an optional accessory Headset, which

is compatible with the 20-2432

20-2432

20-2432.

To purchase a Headset, please call 1-800-651-6791.

Once you have a compatible 2.5mm Headset, locate the Headset Jack on the

20-2432

20-2432 Handset. Connect the plug on the Headset cord to the jack(under a

small rubber flag) on the cordless Handset. The plug should fit securely. Do

not force the connection.

Headset Operation connected to

the Handset

NOTE :

Whenever a compatible Headset is

connected to the cordless Handset, the

microphone on the Handset will be

muted. This is done to limit the effect

of background noise.

Headset Operation connected to

the Base Unit

The same type of Headset can be

connected to the Base Unit. Facing the

Base, the Headset jack can be found

on the near corner of the right side

panel.When using a Headset attached

to the Base, calls are made and

answered by pressing the HEADSET

HEADSET

key. This key is also used to end your

call. The Base Speakerphone and

Base Headset cannot be used

simultaneously. However, you can

switch between the two modes by

pressing SPEAKERPHONE

SPEAKERPHONE

SPEAKERPHONE and

HEADSET

HEADSET without disconnecting

your Headset.

Belt Clip

The 20-2432

20-2432

20-2432 is also equipped with a

detachable belt clip. Align the pins

on the inside edge of the clip with

the notches on the sides of the 20-

20-

2432

2432 Handset. The belt clip should

snap securely into place. Do not force

the connection.

Additional InformationAdditional InformationAdditional InformationAdditional InformationAdditional Information