VBrick Systems Portal Server ETV v4.2.1 - Manual (Page 141)

EtherneTV Backup
ETV Portal Server Admin Guide 129
Configuring ETV Backup
To configure EtherneTV Backup, you must perform all of the following steps in the exact
sequence shown.
1. Enable the Warm Backup Server
If you purchased ETV Backup, two Portal Servers will be present at your site—one of which
must be configured as a warm backup. By default, the warm backup option is disabled on both
servers.
T To enable a warm backup server:
1. On the server machine that will be used as the warm backup, go to
Start > Control Panel
> Add or Remove Programs > VBrick Media Control Server Suite
.
2. Click
Change/Remove
and on the following window select
Enable/Disable Warm Backup
Server
.
3. On the following window, select
Enable
and click
Next
, then
OK
to exit. This will
complete the configuration and there is no need to reboot the server.
4. When finished, launch ETV Backup using the desktop icon.