VTech DECT 6.0 CS6114 - Manual (Page 15)

12
Telephone operation
Temporary ringer silencing
When the telephone is ringing, you can temporarily silence the ringer of the
handset without disconnecting the call. The next call rings normally at the
preset volume.
To silence the handset ringer:
Press OFF/
CANCEL
or MUTE/
DELETE
and
Ringer muted displays.
Temporary tone dialing
If you have pulse (rotary) service only, you can switch from pulse to tone
dialing temporarily during a call. This is useful if you need to send touch-
tone signals to access your telephone banking or long distance services.
During a call, press
TONE
.
Use the dialing keys to enter the number. The telephone sends
touch-tone signals.
The telephone automatically returns to pulse dialing mode after you end
the call.
Find handset
Use this feature to find the system handset.
To start paging:
Press /FIND HANDSET on the
telephone base once and then release
when the telephone is not in use.
The system handset rings and
** Paging ** flashes on the screen for
60 seconds.
To end paging:
Press /FIND HANDSET on the telephone
base once and then release.
-OR-
Press /
FLASH
or any of the dialing keys ( 0-9,
TONE
or
#
) on the
handset to stop the paging tone.
•
1.
2.
3.
1.
2.
•
•
Ringer muted
10:15
PM
12/25
Do not press and hold /FIND HANDSET for more than four seconds.
It may lead to handset deregistration. If Not registered displays on the
handset, refer to Troubleshooting on page 26 to register the handset to
the telephone base.