Vivotek PZ6114/PZ6124 - Manual (Page 61)

- 57 -
www.vivotek.com
T: 886-2-82455282
F: 886-2-82455532
Viewing System Log
Click on the link on the configuration page to view the system log file. The content of
the file provides useful information about configuration and connections after system
boot-up.
Viewing System Parameters
Click on this link on the configuration page to view the entire system’s parameter set.
The content is the same as those in CONFIG.INI.
Factory Default
“Factory default”
Click on this link on the configuration page to restore factory default settings. Any
changes made so far will be lost and the system will be reset to the initial factory
settings. After clicking on the “Restore” button and make confirmation, the system
will restart and require the installer program to set up the network again.
“Calibrate”
Recalibrate the home position to the default center to recover the tolerance caused by
some external forces. This function is the same as the “Center” button on the Remote
Controller. Please note that there is no confirming message box after clicking on the
“Calibrate” button, the Network Camera will calibrate immediately.