VIEWSONIC E70fb - Manual (Page 6)

ViewSonic E70fB/E70fSB 4
Quick Installation
1. Connect power cord
Connect the power cord to a properly
grounded AC outlet.
2. Connect video cable
Make sure both the monitor and
computer are turned OFF.
• Connect the video cable to the
computer.
Macintosh ® users: Models older than
G3 require a Macintosh adapter. Attach
the adapter to the computer and plug the
video cable into the adapter.
To order a ViewSonic ® Macintosh
adapter, contact ViewSonic. See
“Customer Support” on page 12.
3. Turn ON monitor and computer
Turn ON the monitor, then turn ON the
computer. This sequence (monitor before
computer) is very important.
Note : At this point Windows users may
receive a message asking them to install
the INF file.
4. Install Display Optimization files
(INF and ICM files)
(1) Insert the ViewSonic Wizard CD-
ROM into your computer’s CD-ROM
drive.
Note : If your computer does not have a
CD-ROM drive, see “Customer Support”
on page 12.
(Continued)
(2) Wait for the CD-ROM to auto-start.
Note : If the CD-ROM does not auto-
start:
double-click on the CD-ROM icon in
Windows Explorer, then double-click on
viewsonic.exe.
(3) Follow the on-screen instructions.
5. Windows users: Set the Timing
Mode (resolution and refresh rate)
Example: 1280 X 1024 @ 75Hz.
For instructions on changing the
resolution and refresh rate, see the
graphic card’s user guide.
Installation is complete. Enjoy your
new ViewSonic color monitor.
To be best prepared for any future
customer service needs: print this user
guide and write the serial number in
“For Your Records” on page 2. (See
back of monitor.)
To register your product go online to
www.viewsonic.com.
The ViewSonic Wizard CD-ROM also
provides an opportunity for you to print
the registration form which you may
mail or fax to ViewSonic.
Video cable
Power cord
AC wall outlet