Viking F20022J EN - Manual (Page 3)

5
•To remove drawer assembly, pull warming drawer pan out until fully extended. Slide finger along the right
and left side until you reach the black hand latches (located at the front of the rails). Pull up on both the
right and left latches and pull drawer pan support completely out.
•Slide cavity assembly into cabinet opening.
•Drill (4) pilot holes in cabinet using 1/8” drill bit. Permanently secure the warming drawer using the (4) #8
mounting screws provided.
•Replace drawer assembly.
Model DFWD170 DFWD100
25 1/4” 28 1/4”
A (64.1 cm) (71.8 cm)
CABINET INSTALLATION
CUSTOM FRONT INSTALLATION
•Open the drawer and remove the pan.
•Center the custom front and insulation around the inside panel.
*NOTE: Make sure the insulation provided is used between the custom panel and the inside door panel.
•Attach the custom front with the (6) six #8 x 3/4” screws provided.
Cabinet
Cavity Assy.
Mounting Screws
(4) - #8 x 3/4”
(6) - #8 x 3/4” screws to
attach custom front
custom front insulation
DFWD - CABINET CUTOUT
24”
(61.0 cm)
9 5/8”
(24.4 cm)
FRONT
REAR
2 1/2”
(6.4 cm)
2 1/2” (6.4 cm)
SIDE
10”
(25.4 cm)
B
C
9 1/2”
(24.1 cm)
27” (68.6 cm)
22” (55.9 cm)
23” (58.4 cm)
1 1/2” (3.8 cm)
4
MODEL DEWD170 DEWD100
B 26 1/2”(67.3 cm) 29 1/2” (74.9 cm)
C 24 7/8”(63.2 cm) 27 7/8” (70.8 cm)
Interior width 18 7/8 (47.9 cm) 21 7/8” (55.6 cm)
Interior height 5 7/16” (13.8 cm) 5 7/16” (13.8 cm)
Interior depth 21 3/16” (53.8 cm) 21 3/16” (53.8 cm)
Approx. shipping
Weight
80 lb. (36 kg) 90 lb. (40.5 kg)
120V Electrical opening